|
|
Post by papi19934 on Oct 13, 2007 20:02:33 GMT -5
I'm dragging the passenger side stand on right turns, not even hard turns. It sticks out farther there to clear the stator cover. Has anyone else experienced this on their scoots and does anyone have a suggestion?
Thanks
|
|
|
|
Post by WarrenS on Oct 14, 2007 10:44:50 GMT -5
I may be stating the obvious but check your tire pressure. Then look at the stop that the stand hits when it is raised.
|
|
|
|
Post by natefromogden on Oct 14, 2007 11:17:47 GMT -5
Yeah, stand dragging isn't something normally reported around these parts. Either us Dawgs are lazy and not working on our turns very hard, (I know I don't) or perhaps your stands aren't folding up all the way. Either that or you're a much more enthusiastic corner carver than most of us. So make sure about the tire pressures and then get underneath and see if everything is fitting where its designed to be.
My Morphous is a really low slung beast and though I haven't tried to drag anything, nothing touches around the sharpest turns I negotiate.
|
|
|
|
Post by papi19934 on Oct 14, 2007 15:30:05 GMT -5
This isn't aggressive cornering. The right stand extends out further than the left to clear the side cover. I removed the left side rubber roller that hits the stop to let it go up farther and it is much better. I will re-drill the pivot hole for it and grind a little on the right side pad and see how it works. Believe me, on these little cheng shin's I ain't carvin' any corners. I'm an ex-Enduro rider not a roadracer.
|
|
