|
Post by knorrtech on May 20, 2007 12:22:18 GMT -5
Hi all - Working on the bike today to change the oil and then gear oil, the oil went fine. I have the scootdawg manual and it went as dipicted. I did find some tiny shavings in the oil so I am glad I changed it, I have 124 miles on it. This is a 250cc jmstar bike but can not find any pics to tell me where to put the oil in, on my other 150, it was just as dipicted in the scoot manual. but this one is difficult, I did find the drain according to the manual (2 yellow boxes around it) and the manual that came with the bike. There was a hole that I took the screw out that read 250 cm on the black plastic cover, I put the oil in there it dripped out, I took the black panel off and the hole is just a screw hole and blank in back(4 yellow boxes aroung this). Can anyone guide me where to put the oil in according to the pictures below - as alway, thank for your help.
|
|
|
Post by WarrenS on May 20, 2007 13:51:54 GMT -5
I have a Morphous so it probably is not the same but the filler is seen from the back of the scooter. It is located behind the CVT case and shock absorber. Look near the top of the case next to the wheel. Mine has a plastic thing that you can turn by hand to unscrew. I hopes this helps you.
|
|
|
Post by knorrtech on May 20, 2007 19:33:01 GMT -5
Thanks - That was it. It is a lot easier to fill than the 150, I could just pour it in. Thanks I just could not find it, but it was exactly where you said. I have a burgman too but not riding it until I can practice on the smaller bike.
Thanks again
|
|
|
Post by WarrenS on May 20, 2007 23:00:55 GMT -5
I am just happy I could help.
|
|