|
|
Post by crazyirishman on Nov 28, 2012 10:58:23 GMT -5
What needs to be done to remove the front turn signal bulbs from my '07 MC 54B? (just turned over 12,000 thank you very much!) I've got big mitts and can't get to the bulbs!  Attachments:
|
|
|
|
Post by richardthescooter1 on Nov 29, 2012 19:28:56 GMT -5
Welcome to our forum crazyirishman, To get to those turn signal lights, it would be easier to take the front off. Attachments:
|
|
|
|
Post by winchesterboy on Dec 1, 2012 17:27:38 GMT -5
With big mitts this might not be doable but...
If I remember right, using a stubby philips screw driver( or maybe a 1/4" drive ratchet with a philips bit), you can reach up under the front fairing and remove the single(?) philips screw and the turn signal assembly will almost fall out to the outside of the fairing. A tab holds the other end in place.
Putting it back into place and getting the screw in, is a lot more fun(?), than removing it.
I really hate to remove the front fairing unless there is no other way!
|
|
