|
Post by richardthescooter1 on Oct 21, 2012 7:32:37 GMT -5
I have the mc-54-250b roketa scooter, In need of intake manifold. Hard to find can any of you Dawgs help me Fix for now but need one in near future. Attachments:
|
|
|
Post by zfjelstad on Oct 21, 2012 19:56:38 GMT -5
|
|
|
Post by zfjelstad on Oct 21, 2012 20:06:05 GMT -5
|
|
|
Post by macktheknife on Oct 21, 2012 21:25:47 GMT -5
Nope neither one of them is correct, just like in Richard's picture the 250B linhai intake manifold has two vacuum ports.
|
|
|
Post by prodigit on Oct 21, 2012 22:52:41 GMT -5
It's not too hard to make a splitter plug, or drill a hole and plug in the plug with some silicone.
|
|
|
Post by richardthescooter1 on Oct 22, 2012 8:58:06 GMT -5
Thanks guys, if I have to I could buy the one port and remove emissions stuff.
|
|
|
Post by jlee on Oct 26, 2012 1:19:30 GMT -5
Thanks guys, if I have to I could buy the one port and remove emissions stuff. That's what I would do, but you CAN use the single port intake and leave everything else the same - just add a vacuum tee off the one port to get two...
|
|
|
Post by EPAhater on Oct 26, 2012 9:19:25 GMT -5
Two things, the emmission stuff causes no performance issues as long as it's all properly hooked up and second even though you can put a Tee in and use one vacuum port it's better to use a "Y" connector.
The linhai does better if you isolate one port to the fuel pump only and run the second port for the other items. Not hard to add a second port even on a new single ported intake.
|
|
|
Post by richardthescooter1 on Oct 26, 2012 9:54:33 GMT -5
Where would you buy the port at?
|
|
|
Post by richardthescooter1 on Oct 26, 2012 9:58:16 GMT -5
Here is the pic of where the vacuum lines are now The one closest to carb goes to fuel pump and carb, back one goes to canister and emission stuff. Attachments:
|
|