|
|
Post by mnfitz on Sept 12, 2012 20:13:13 GMT -5
Turns out the needle screw on my carburetor bowl drain vibrated loose emptying the bowl. Tightened it up, and it vibrated loose AGAIN within about 5 miles...
|
|
|
|
Post by gatekeeper on Sept 12, 2012 20:37:41 GMT -5
Clean the end good and put the screw back in tight. Then take a tube of silicone sealant and glob it over the end of the screw and fitting. Let it cure over night and you should be good to go. The sealant will prevent the screw from backing out but is easy to peal off if you ever need to take the screw out again.
|
|
