msgusaf
Big Dawg
Retired MSGT USAF
Posts: 18
|
Post by msgusaf on Sept 8, 2012 11:29:14 GMT -5
I noticed a lot of you guys use UNI Air Filters in place of the stock filter. As my filter housing broke yesterday, what kind of uni Filter is suggested for a 150cc GY6 engine in a 2012 Cyclone? Also what size?
|
|
|
|
Post by ibtrikin on Sept 8, 2012 12:22:47 GMT -5
www.monstergy6.com has them. You'll need something to go between the carb and filter though. A lot of guys use a short velocity stack, but I used some of the rubber hose that was on the original filter setup. Grab a #110 main jet while you're at it. The UNI will take in more air and you don't want to run lean.
|
|
|
|
Post by wiredgeorge on Sept 8, 2012 17:05:36 GMT -5
Another thing that you could do is use a disposable EMGO 43mm ID filter pod. You can get a hose at Home Depot that will fit over the end of the carburetor; clamp it on. Then put a piece of PVC into the hose and clamp it on the hose and then clamp the filter onto the PVC. I like the cheap and disposable EMGO filter because it is good for a year or two of riding and costs about $5. You don't have to wash/oil this thing and oiling a filter is probably one of the easiest ways to upset your air/fuel mixture as folks tend to be real generous with the squirt oil.
|
|
|
|
Post by tvnacman on Sept 8, 2012 17:11:44 GMT -5
|
|
