|
Post by xingue150 on Aug 29, 2012 13:58:08 GMT -5
I recently replaced my starter, starter clutch, and stator on my 2008 Xingue 150 (GY6). Afterwards my scooter started right up and ran just fine. However, on my first drive it began sounding a bit funny and shut down. I didn't try to restart it again until I could check things as I assumed that I must have done something wrong. After removing my fan cover, I discovered that my flywheel nut must have not been tight enough and had come loose. I replaced the flywheel and tightened the nut tighter. However, now when I try to start in just turns over and over with no indication of actually starting. I am totally unfamiliar with my scooter's electrical system so I would very much appreciate any ideas, steps, or procedures to determine what has been damaged and how to fix my scooter. THANKS!
|
|
|
Post by tvnacman on Aug 29, 2012 17:51:12 GMT -5
You need to post a picture .
John
|
|
|
Post by wile on Aug 29, 2012 20:59:59 GMT -5
When you replaced the Flywheel did you see the WOODRUFF key in the crankshaft that the FLYWHEEL SLOT fits onto? The Woodruff key could have fallen out and or moved out of position and now it is out of time. The woodruff key holds the FLYWHEEL in a certain position so it does not rotate on the crankshaft. Wile
|
|