|
|
Post by barry1013 on Aug 24, 2012 17:01:35 GMT -5
;D How do you remove the seat and storage pan on a 2011 Johway TT250Y..? I need to look at the carburetor. Leaking gas, need more room to see.
thanks
|
|
|
|
Post by richardthescooter1 on Aug 25, 2012 7:14:40 GMT -5
Can you post pic wth seat opened?
|
|
|
|
Post by dumbass on Aug 25, 2012 13:01:24 GMT -5
If it's like the Roketa 250 54b removing the seat will not get you to the carb. You will need to remove the seat and all the skin as well. I replaced the carb on the 54b through the inspection hole. Tight and hard area to work but it was easier and faster then removing all the skin.
Bob
|
|
|
|
Post by barry1013 on Aug 25, 2012 13:47:15 GMT -5
I would thing if you remove the seat9 two #19 nuts on the side) then remove the storage part under the seat you would have a good look from the top sown to see.
|
|
|
|
Post by dumbass on Aug 26, 2012 10:58:02 GMT -5
I would thing if you remove the seat9 two #19 nuts on the side) then remove the storage part under the seat you would have a good look from the top sown to see. I think on most bikes the storeage compartment can only be removed after removing the plastic skin (fenders). Bob |
|
|
|
Post by barry1013 on Aug 26, 2012 12:17:50 GMT -5
No camera darn it but remember there are two 54B's or YY250T. The CN250 with the Honda vertical clone engine and the CL horizontal engine. The seat pan's maybe different.
|
|
|
|
Post by dumbass on Aug 26, 2012 18:07:13 GMT -5
No camera darn it but remember there are two 54B's or YY250T. The CN250 with the Honda vertical clone engine and the CL horizontal engine. The seat pan's maybe different. The true 54b has the 257cc engine (horizontal) and the vertical engine is a 54 (no b). Bob |
|
|
|
Post by meworrynot on Aug 30, 2012 22:19:51 GMT -5
To remove the seat there are 2 nuts on the hinge plate, 10mm socket. Next remove the luggage rack, 3 bolts (can be unbolted with the trunk still attached) Think they were 12mm socket. Next is the fender, 2 screws under taillight then 4 screws under that small plate. remove screws around the under seat storage opening, 6 I think. Then the screws at the bottom of the panels near the passenger foot pegs, 2 or 3 per side. Should lift off while pulling sides apart slightly. Watch for the tail lights, twist them out. Remove the seat lock cable. Next remove the bolts holding the storage box, 10mm socket, I think there were 6 of them. Watch for other screws on the fenders, dont want to break any tabs. Then you can get at carb very easily. Where is the leak coming from?
|
|
|
|
Post by meworrynot on Aug 30, 2012 22:23:49 GMT -5
Also check your anti freeze line going to carb, mine had rubbed through on the electrical harness. The little short line was the one. I also zip tied any loose hoses and electrical so they could not rub. I have the same scoot with the CF moto engine.
|
|
