|
Post by zero1knight on Aug 8, 2012 17:10:00 GMT -5
Trying to figure out why I am not getting spark from plug. I have a gtr 50 and I am rebuilding it. I disconnected my sensors and cdi and still not getting spark changed plug and coil. Any ideas?
|
|
|
Post by wile on Aug 8, 2012 18:30:48 GMT -5
Do you have the Motor grounded to the Frame. Does it spark on the Frame? Also since your rebuilding it WHAT HAVE YOU CHANGED in regards to Flywheel, Stator pickup coil etc.. The parts that feed the COIL. Wile
|
|
|
Post by zero1knight on Aug 8, 2012 19:52:31 GMT -5
Right now I have changed cylinder head to a 70 cc clutch and variator rejetted the carb and exhaust. Right now just trying to get it started everything is hooked up right now. I have not changed the stator or flywheel. I am still new to scooters am I missing something.
|
|
|
Post by wile on Aug 8, 2012 21:59:52 GMT -5
You do know you have to have the wires plugged into the CDI RIGHT? The only wire that you should try to take off is the KILLWIRE which is on the TWO PLUG the TOP ONE usually Black and White, but everything else plugged in. Wile
|
|
|
Post by zero1knight on Aug 9, 2012 17:09:02 GMT -5
Did that, pretty sure it was the line anyway was black and white like u said.
|
|
|
Post by wile on Aug 9, 2012 17:20:59 GMT -5
Here is the CDI and you can see the KILLWIRE: Wile
|
|
|
Post by zero1knight on Aug 9, 2012 18:06:04 GMT -5
That's the one I removed but on my Cdi the connections are all in one there is no 2 pin set up its five pin and all in same plastic connector. I had to clip the wire
|
|