|
|
Post by 22cents on Jul 30, 2012 2:06:53 GMT -5
Hi,
My SUNL 250 scooter had another problem.
Just changed a tail light bulb yesterday. It cranked ok and started fine.
However, I was not able to start the scooter this morning. It cranked but did not start.
The battery is new.
I smell some gas when I was not able to start the engine. The crank sounds very strong but the engine just did not start.
Thanks
|
|
|
|
Post by gatekeeper on Jul 30, 2012 4:41:47 GMT -5
Make sure the kill switch is in the "run" position. Does the brake light come on when you squeeze the handle? Check for spark. Pull the spark plug, re-insert it into the cap and hold the metal end of the plug against the engine while hitting the start button. See if it sparks.
|
|
|
|
Post by 22cents on Jul 30, 2012 11:36:53 GMT -5
Thanks for the help.
It seems that the spark plug was somewhat loose. I tighten the wire and the scooter can be started now.
|
|
|
|
Post by richardthescooter1 on Jul 30, 2012 12:08:42 GMT -5
Thats why I coverted my over to the snap on spark plug cap.
|
|
|
|
Post by hunter7jl on Jul 30, 2012 20:59:52 GMT -5
How do you convert it to the snap type ?
|
|
|
|
Post by boosterb16 on Jul 30, 2012 21:12:59 GMT -5
i would like to kno the same actually
|
|
|
|
Post by richardthescooter1 on Jul 31, 2012 7:49:09 GMT -5
It is an easy process, I bought this at my local yanaha shop, make sure it has the brass cup inside, then unscrew the boot off your ignition coil and screw this new spark plug cap on, when tight tape it  Attachments:
|
|
|
|
Post by richardthescooter1 on Jul 31, 2012 7:50:54 GMT -5
put this NGK plug terminal nut on your spark plug. Attachments:
|
|
|
|
Post by hunter7jl on Jul 31, 2012 16:48:44 GMT -5
Thank you very much
|
|
|
|
Post by richardthescooter1 on Jul 31, 2012 16:50:47 GMT -5
Your Welcome.
|
|
