|
|
Post by parsonsj11 on Jun 20, 2011 15:30:11 GMT -5
hey guys anyone with a magnum i would really appreciate it if you could take the carbureator access plate off under the seat and take a picture that shows the intake valve cover.. I didn't take a picture and when putting it back found out it mounts either way and need to know which way is right.. it has a raised place on one side lol......
Thanks in advanve to anyone who takes the time and effort to help..
James
|
|
|
|
Post by leeinark on Jun 20, 2011 15:44:41 GMT -5
James: If you were sitting on the engine as if you were riding it (without a seat or fairings) the raised side would be on the left. If I understand your question correctly. vr, Lee
|
|
|
|
Post by parsonsj11 on Jun 20, 2011 15:46:50 GMT -5
ya the exhaust valve cover has three screws and only goes on one was but the intake can go on either way and i want to get it back on the right way thanks......
|
|
|
|
Post by leeinark on Jun 20, 2011 16:00:26 GMT -5
You bet! By the way it will be very obvious if it is on the wrong way. A check for it is to turn the motor over until the valve is up and place the cover on it. If it's going to hit the cover then turn it over.
|
|
|
|
Post by mike6736 on Jun 20, 2011 21:05:49 GMT -5
Lee you are ccorrect as I had to do just that when I did my valves
Mike
|
|
.........
........