|
Post by mgreenfield on Jan 4, 2008 19:18:20 GMT -5
...got most of the plastic off my Roketa Jamaica now, & note the weld joints are pretty rough.
They look a lot like welds my farmer uncles would do to repair a broken combine or similar. Just electric 'stick' welds. No MIG/TIG welding for sure!
AND I note that there's already a little rust in the rough pits, valleys and grooves of these welded areas.
What's good product I can spray or brush into those areas to keep the rust from expanding any further into the weld joints??
A broken frame weld could be a pretty serious safety hazard.
Many thanks!
|
|
|
Post by swampsniper on Jan 4, 2008 19:52:27 GMT -5
Look for "Ospho" or "Phospho". Paint it on, let it dry. Works best if the metal isn't cold.
|
|
|
Post by earlwb on Jan 4, 2008 22:20:32 GMT -5
the BBQ grill paint comes to mind too.
|
|
|
Post by scooterollie on Jan 4, 2008 22:30:07 GMT -5
Also, there are a number of rust converter primers on the market. Brush them on and let them dry, then follow with a good paint - Rustoleum is a high quality enamel that works well. Almost anything over a rust converter is OK.
I have noticed the same on previous Chinese scoots I have had. Mine doesn't sit out in the weather but I could see that if I had kept them outside, the rust would have spread rapidly. The frame construction quality on the Linhai is much better.
|
|
|
Post by mgreenfield on Jan 5, 2008 22:06:52 GMT -5
Thanks for the tips, gentlemen. Went out today & got some Ospho-like rust converter, ...couldn't find any real Ospho, and some Rustoleum! The precision of the fit-up of the frame pieces, AND the quality of the welds on this scoot are BOTH jokes. I'm surprised it rides in a straight line, ....but it does, and very nicely. It's a Chinese miracle!
|
|