Post by aznatama on Feb 13, 2013 1:18:52 GMT -5
After doing a lot of research, it seems like I might need to upgrade my charging system to install HIDs. Has anyone tried to install the gy6 stator on the 40qmb?
I know hte rotor is a different size, with the 40qmb's rotor is just a tad bit smaller. the problem is, I can't seem to find measurements on the shaft diameter and taper of the gy6 vs 40qmb rotors.
Any suggestions? I will be replacing all the bulbs that run off of DC current w/ LEDs to reduce load on the system, and I want to run a single 35w HID via a relay direct from the battery. I'll have the high beam still using the stock halogen for daytime use though.
I know hte rotor is a different size, with the 40qmb's rotor is just a tad bit smaller. the problem is, I can't seem to find measurements on the shaft diameter and taper of the gy6 vs 40qmb rotors.
Any suggestions? I will be replacing all the bulbs that run off of DC current w/ LEDs to reduce load on the system, and I want to run a single 35w HID via a relay direct from the battery. I'll have the high beam still using the stock halogen for daytime use though.