|
Post by cougarcruisin on Jun 9, 2008 9:00:29 GMT -5
On my 150cc GY6: Okay here is what I did. I removed the PAIR system on my bike. I removed the stock airbox and replaced with a hi-flo filter. Meaning that 2 of the 3 vacuum hoses coming from that air canister are now gone, leaving 1 small hose.
How would I run my vacuum lines now? Can I remove that air canister now?
1 Line from intake manifold to vacuum petcock 1 Line from other side of Intake manifold to Carb?
|
|
|
Post by earlwb on Jun 9, 2008 10:40:03 GMT -5
yes that is it. You got it.
|
|
|
Post by anthonyvs on Jun 9, 2008 12:22:42 GMT -5
You also have to figure out what to do with your pcv port on your valve cover. I made an oil catch can that condenses the oil vapors. Then the outlet goes to a connector I installed between the carb and the air filter. This will supossedly reduce carbon build up on the valves. I made my catch can out of 1.5" pvc pipe and two end caps. Inside is some scouring pads at the inlet and at the top is a piece of foam from a lawn mower air cleaner. some people just install a breather on the valve cover. But they still allow oil to get on everything.
|
|
|
Post by cougarcruisin on Jun 9, 2008 21:25:40 GMT -5
Thanks guys for the input
|
|
|
Post by yarddogbbq on Jun 10, 2008 3:44:18 GMT -5
plug the small line. the vacuum will make a lean condition.
|
|