toooan
New Puppy Dawg
Posts: 1
|
Post by toooan on Sept 24, 2012 16:36:42 GMT -5
Yesterday, when I turned the key knob in the ignition, I wasn't able to start the scooter (I noticed because the gas meter thing on the dash didn't move). However, today when I tried again, it started. I turned it off, and then 10 minutes later I tried again and it wouldn't turn on. Any idea what's wrong with it?
|
|
|
Post by derbi on Sept 24, 2012 16:41:01 GMT -5
Welcome to the forum. A short in the electrical system, Bad kill switch a bad fuse or a bad ground would be my guesses.
|
|
|
Post by jcz775 on Sept 24, 2012 17:11:42 GMT -5
Start going threw your wiring starting at the ignition. Very simple. Good luck.
|
|
|
Post by Tragik on Sept 24, 2012 18:46:50 GMT -5
Check your ground wires...mine and another member here had the same problem...
Sent from my p0rn infested Inspire 4G using ProBoards Pro
|
|
|
Post by mules5555 on Sept 25, 2012 0:41:46 GMT -5
I would start with just your simple battery connections. They could be loose or corroated. so start simple ans go from there
|
|
|
Post by justmopeds on Sept 25, 2012 12:32:28 GMT -5
The first thing you can try is bypassing your fuse box and see if your bike turns on, i had a short on the positive (red) wire going from the fuse box to the battery which was a easy fix. You can also make sure your ground wire either one or two are connected to the engine valve cover, sometimes it comes off and you will have a shortage and the bike will only start when there touching. The wire harness is fairly cheap I would replace the entire wiring system!!....www.justmopeds.com
|
|