|
Post by timothywarner1989 on Oct 6, 2011 3:07:33 GMT -5
Please help. I am gnna tell all the info I can I really need help. I have a 2004 zebra made by the tuoche company. The battery was dead when I got it so I had to jump start it and the starter relay was bad so I ran it straight to starter and of course wore it out and had to replace it. I bought a new starter, fuel filters, and starter relay. Still have no battery but after installing new parts the scooter didn't idle right so I tried cleaning Carb an adjusting idle screw on side of Carb Scooter will start an idle but will die after a min. Plus sometimes the clutch engages while idling and when u apply back brake the scooter dies. And sometimes. after using the electric start when you try to use left(back) brake the starter engages!!!! I don't know wat could have went wrong to cause all this but any info or ideas on any or all of these problems would be so greatly appreciated. I really need my scooter going it my only transportation. Thank you.
|
|
|
Post by sprocket on Oct 6, 2011 9:58:27 GMT -5
When you jump started the scooter was the car and truck running? ?? If it was running you may have fried the scooter electrical system Also sounds like you have a short on the left brake level...the starter shouldn't engage...
|
|
|
Post by timothywarner1989 on Oct 6, 2011 10:54:09 GMT -5
I used a battery charger in 12 volt medium to jump it. Bit if it was fried it wouldn't start at all would it?
|
|