|
Post by sonofpear on May 1, 2011 13:44:15 GMT -5
Ok I know this has been said 1000 times but I am bypassing my alarm and I was looking at the wires I see coming from the alarm is a black wire and a brown wire. the other end has a black wire w/ white stripe a white wire w/black stripe and a solid black wire. the question is what do I bridge together? Please help so I can ride today and that stupid alarm will be gone.
|
|
|
Post by sprocket on May 1, 2011 13:48:57 GMT -5
Normally the brown/white striped and the black/white stripes are bridged.
Unfortunately you don't have these so I can't help you...
I would try the striped wires, but you may blow a fuse...
|
|
|
Post by sonofpear on May 1, 2011 14:02:58 GMT -5
I can post pictures if needs be but the two striped wires are not coming from the alarm they are on the connector. so the solid black and solid brown come from the alarm and the striped white and striped black are on the other side.
|
|
|
Post by sprocket on May 1, 2011 14:18:55 GMT -5
Here is a wiring diagram someone did. You can see the alarm connect in the top left middle... Yours is different but this may give you a clue... Attachments:
|
|
|
Post by sonofpear on May 1, 2011 14:47:34 GMT -5
Ok so here is what I have done I connected the black/white to the white/black on the scooter side and the alarm still goes off but iff I disconnect those then the alarm goes off and i cant kill the scooter so I connect them back together. any other ideas?
|
|
|
Post by sprocket on May 1, 2011 14:56:03 GMT -5
You will need to trace the wires back in the harness and see that they do...
|
|
|
Post by hootymon74 on May 1, 2011 15:38:42 GMT -5
I'm glad that all I had to do was remove mine. No wire jumping... and all is good with the world.
|
|
|
Post by sonofpear on May 1, 2011 17:03:25 GMT -5
I don't know maybe ill just put a new one in I just want to ride and I have no idea also there is a little black box that is always making noise its not my alarm is that my turn signals?
|
|
|
Post by sprocket on May 1, 2011 17:06:53 GMT -5
Probably your turning signals relay...but it should only make noise when the turn signals are one... If the turn signal are off and you hear noise the signal relay may be fried...need to replace it...
|
|
|
Post by sonofpear on May 1, 2011 17:13:14 GMT -5
Well that's hard to say since the alarm never shuts off its always making the blinkers go so I need to figure out the alarm crap first
|
|
|
Post by sonofpear on May 1, 2011 18:21:08 GMT -5
Ok thanks for all the help so far. Here is the update I bridged the two striped wires together with a small piece of wire. So here is the update with those bridged the alarm doesnt seem to go off however the turn signal relay is non stop buzz and the turn signals are on but not blinking just a steady on all the time. Does it sound like I bypassed my alarm and do you think that I now have a turn signal relay issue?
|
|
|
Post by sprocket on May 2, 2011 13:11:58 GMT -5
The alarm probably flashes the turning signals when it goes off. All you are doing is making it try to do this. So don't bridge those wires...
|
|