|
|
Post by mopedjay on Sept 1, 2010 12:04:47 GMT -5
just bought one for $150 from a guy that bought it at a police impound auction the key switch was intact until the guy decided to break it
is there any possible way to hot wire these things theres only 2 wires going to the ignition switch and i tried everything and got nothing
i have the wiring diagram and i can not believe the amount of electronics in this thing theres more wires in this than my ford windstar
why does a scooter need an ECU or a throttle position sensor or any other complicated electronics
i was thinking is there any way to swapping the electronics over to that of a GY6
|
|
|
|
Post by vigorouselbows on Sept 1, 2010 13:45:14 GMT -5
if that scooter works (even after just replacing the ignition switch for a couple bucks) then I think you are the luckiest guy I've had contact with all day.
EDIT:
In addition, you could probably spend a couple thousand repairing/modding it up and it'd still be worth it. I'm insanely jealous.
|
|
|
|
Post by keetarider on Sept 1, 2010 14:07:49 GMT -5
S ame here. lucky lucky man. replace the ignition. fix it up right and you'll forget all about the GY6.  |
|
|
|
Post by mopedjay on Sept 1, 2010 15:31:30 GMT -5
we are thinking the ecu might be toast the guy i got it from grounded a bunch of wires and shorted it out
as far as i can see the gy6 mag will bolt right on and my gy6 runs so the electrics are good and anything is better thats going to make it more simple
|
|
|
|
Post by rocketdog on Sept 1, 2010 17:55:24 GMT -5
|
|
|
|
Post by mopedjay on Sept 1, 2010 19:57:20 GMT -5
yeah i went to total ruckus but it wont let me register it says there was some kind of threat to them so they are not letting new members in
i took the belt housing cover off cause the kicker wasnt working right and having a bunch of oil drip out isnt a good sign so i pulled the variator off to find the crank bearing junk and the seal is torn apart a 4 stroke with bad bearings and seals at 6700 miles well that aint right
the mag side bearing is pretty bad too and the seal is junk so im guessing someone ran it with out oil for a bit
tomorrow il tear the engine apart and see whats wrong
|
|
|
|
Post by mopedjay on Sept 2, 2010 12:16:41 GMT -5
man this morning i took it apart a bit more this thing needs a lot of work more than i want to do with it
so i guess il part it i need to get rid of stuff anyways
|
|
.